FabCAD

Heat-set inserts: hole sizes and how to install them

How to design holes for brass heat-set inserts in 3D prints, typical hole sizes for M2–M5, and how to press them in straight with a soldering iron.

2 min read

Heat-set inserts are small brass sleeves with a metal thread inside and knurls outside. You melt them into a printed hole with a soldering iron. The plastic flows into the knurls and the insert holds very well — perfect for screws that are opened and closed often.

Hole sizes

Always check the size your insert's manufacturer recommends — they differ between brands. Common sizes for short inserts:

Thread Hole diameter Hole depth (at least)
M2 3.2 mm 4 mm
M2.5 3.6 mm 5 mm
M3 4.0 mm 5.7–6 mm
M4 5.6 mm 8 mm
M5 6.4 mm 9 mm

FabCAD's Insert hole (Fasteners & threads in the left panel) uses these sizes and adds a small chamfer at the top so the insert starts straight.

Design tips

  • Leave at least 1.5–2 mm of wall around the insert. Thinner walls bulge or crack.
  • Make the hole a little deeper than the insert, so melted plastic has somewhere to go.
  • Use 3 or more walls (perimeters) around the hole — the insert grips the walls, not the infill.

Installing

  1. Heat a soldering iron to about 220–245 °C for PLA (a bit hotter for PETG/ABS). A dedicated insert tip helps.
  2. Set the insert on the hole and let the iron sink it in slowly and straight — let the heat do the work, don't push hard.
  3. Stop when it's flush, then press it flat with something cold and flat while the plastic cools.
Design it in FabCAD

Free, in your browser, made for 3D printing — threads, fits, hinges and print checks built in.

Open the editor