FDM design rules: 12 rules for parts that print right the first time
Wall thickness, overhangs, bridges, holes, chamfers, text size and strength — the practical design rules for FDM 3D printing, explained simply.
2 min read
Most failed prints aren't the printer's fault — the part simply wasn't designed for how an FDM printer works. These twelve rules cover almost everything that goes wrong.
Size and thickness
- Make walls a multiple of your line width. With a 0.4 mm nozzle, 0.8, 1.2 or 1.6 mm walls print as clean, solid lines. A 1.0 mm wall leaves a weak gap or gets filled with zig-zags.
- Nothing thinner than two lines. Features under about 0.8 mm (with a 0.4 mm nozzle) may not print at all. FabCAD's Print check warns you about thin parts.
- Text needs strokes of 0.5 mm or more. For embossed or engraved text, use bold letters at least 4–5 mm tall and 0.6–1 mm deep.
Overhangs and bridges
- The 45° rule. Each layer can stick out a little past the one below. Up to about 45° from vertical prints fine without support; steeper needs support or a different orientation. FabCAD's Print check colours overhangs orange and red.
- Bridges are fine — if they're short. A flat ceiling between two supports prints well up to 10–20 mm in PLA. Longer bridges sag.
- Use chamfers instead of fillets underneath. A rounded bottom edge starts as a 90° overhang; a 45° chamfer prints cleanly. Use rounded fillets on top edges, where they print perfectly.
- Give horizontal holes a teardrop or diamond top. Round holes lying on their side have a flat ceiling at the top. A pointed top avoids supports and keeps them round.
Fit and accuracy
- Leave clearance between moving parts: about 0.2–0.3 mm per side for parts that slide, 0.1 mm for press fits. See tolerances.
- Chamfer the bottom edge 0.3–0.5 mm to hide elephant's foot (the slightly wider first layer).
Strength and orientation
- Layers are the weak direction. Parts break between layers, so orient them so the force runs along the layers. A hook printed standing up snaps; the same hook printed lying flat is strong.
- Walls matter more than infill. For strong parts, add walls (3–4) before raising infill. 15–20 % infill is enough for most things.
- Big flat parts warp. Round the corners (a 3–5 mm radius helps a lot), and avoid sharp corners on large ABS/ASA prints.
Make it easy to print
- Put the biggest flat face on the plate. FabCAD's Lay on a face does this in one click.
- Split parts that would need lots of support into two pieces with alignment pins or a dovetail.
- Add a fillet where a thin feature meets a thick one — it removes the weak spot.
Design it in FabCAD
Free, in your browser, made for 3D printing — threads, fits, hinges and print checks built in.
Open the editor