FabCAD

3D printing tolerances: how much gap for a press, slide or loose fit

How much clearance to leave between 3D-printed parts so they press, slide or turn — with real numbers for FDM printers and a quick way to measure your own printer.

2 min read

When two printed parts have to fit together — a lid on a box, a pin in a hole, a bolt in a nut — you can't draw them at exactly the same size. FDM printers squeeze plastic a little wider than the line they were told to draw, holes come out smaller than designed, and every printer is slightly different. The fix is clearance: a deliberate gap between the parts.

The short answer

These are good starting values for a well-tuned printer with a 0.4 mm nozzle. They are per side — a 10 mm pin in a slide-fit hole means a hole of 10 + 2 × 0.25 = 10.5 mm.

Fit Gap per side Feels like Use it for
Press fit 0.05–0.1 mm Needs a firm push, holds by itself Pins, magnets, bearings, alignment pegs
Slide fit 0.2–0.3 mm Moves freely, little play Lids, drawers, printed threads, hinges
Loose fit 0.4–0.5 mm Clearly loose Parts that must never bind, print-in-place mechanisms

Why holes come out too small

  • Squish: each line is pressed slightly wider than the nozzle, so walls grow outward — into the hole.
  • Polygons: slicers draw circles as many short straight lines, which cuts a little off the inside.
  • Shrinkage: plastic shrinks as it cools, pulling holes tighter (ABS and ASA more than PLA).
  • Horizontal holes (axis lying flat) sag at the top. Make them a bit bigger, or give them a pointed "teardrop" top so they print without support.

Measure your printer once

Numbers from the internet are a starting point. Five minutes of testing tells you the real values for your printer and filament:

  1. Print a test piece with the same pin in holes that are 0.1, 0.15, 0.2, 0.3 and 0.4 mm bigger per side. In FabCAD, choose Add a fit test print (nothing selected, right panel).
  2. Push the pin into each hole. The tightest one that goes in by hand is your press fit, the one that turns freely is your slide fit, the one with visible play is your loose fit.
  3. Enter those three values in FabCAD's Fit profile. From then on, any hole set to Press, Slide or Loose uses your printer's real numbers.

Tips

  • Test with the filament you actually use — PETG often needs a little more clearance than PLA.
  • Elephant's foot (a wider first layer) makes parts stick together at the bottom. A 0.3–0.5 mm chamfer on bottom edges fixes it.
  • Long fits (a drawer, a sliding lid) need more clearance than short ones, because small errors add up along the length.

Try it: the box with lid generator and the thread generator both use these fits.

Design it in FabCAD

Free, in your browser, made for 3D printing — threads, fits, hinges and print checks built in.

Open the editor